[MusicallyInspired]

So I've split a sector in two and I want to mask the wall of the split sector. In build this was always done with M and it even says that it's M in the Mapster help but it doesn't do anything. What's going on?

[diehard]

MusicallyInspired, on May 25 2009, 03:36 PM, said:

So I've split a sector in two and I want to mask the wall of the split sector. In build this was always done with M and it even says that it's M in the Mapster help but it doesn't do anything. What's going on?

I run into this alot, bump one of the sectors down and then press m against the wall you just created and then just bump the sector back up.

[MusicallyInspired]

Well that's annoying. Oh well...thanks.

[Sangman]

MusicallyInspired, on May 25 2009, 09:49 PM, said:

Well that's annoying.

Don't worry, you'll get used to it.

[Daedolon]

This is what I never get used to with Mapster32, someone did work a fix around to this,it also fixes the other cursor issues like the inability to select a sector floor/ceiling if you're not in that sector yourself, which is the worst issue I'm having with the editor.

I don't think it ever became a patch you could easily apply to Mapster32 yourself though

[Jimmy]

I never have this kind of problem, but I only map in 8bit, so... try mapping in 8bit.